![]() ![]() ![]() Next as a long shot & probably not a contributing factor, but worth a try as it easy, check/adjust the decent knob under the seat using minor clockwise increments at a time. Sounds to me if you're lucky that it might be a simple case of needing to bleed the air from the hydraulics (normally this sytems should self purge air with use), if not use the attached extract from the service manual detailing the process (though note not all machines have this bleed screw). The Bolens G174 is basically the same as the Iseki TX2160 & TX1500F ( the only major difference is some earlier machines use a 2cyl engine & later machines have a 3cyl - all built in the same factory/same design with most items- other than those specific to the 2cyl or 3cyl engines - are interchangeable or "will fit")įirst check the hyd oil level is correct via the dipstick, located down just left of the gear lever- I use/recommend Castrol AGRI AS Trans Plus for the tran/hyd - as alternatives you could use Castrol AGRI MP PLUS, Castrol VMX80, Castrol Manual VMX 80W they're all suitable oils for this application Welcome to the forum & thanks for creating this post (I wasn't able to respond to your previous PM effectively as I couldn't create attachments) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |